How To Install Wood Veneers On Cabinets – Easy Steps You Shouldn’t Miss

How to install wood veneers on cabinet doors is a question often asked by doing it yourselfers. There are many benefits of doing this, especially if your cabinets have seen a lot of use over the years. In fact, they can often look quite worn over time, even though most of us will never actually see them or use them. Garage Gear Guru’s guide on installing wood veneers on cabinets will also make the whole project easier.

The wood veneers themselves are also very durable, and attractive, but the question remains as to how to make them match the rest of the decor in the room. Here are some tips for doing just that. The first step is to get the veneer material ready.

You can either have the veneer material cut to size or you can prepare to paint the veneer with an exact color. It really depends on the look you want to achieve. If you have already purchased doors with the same color or design as the veneer, then it may be easiest just to use that material for your first project.

However, if you are just making a matching set of doors, then you may decide to use a ready-made color or design. If you are painting, then you will need to make sure that the room is properly ventilated. If there is not enough ventilation, the wood veneers could look hollow.

Also, you can buy a kit that includes a fan and venting system already installed. Another option is to make sure that the room has good lighting. A lot of the time, we are too busy looking at the wood veneers to notice lighting problems. When it comes to installation, it is always best to have a helper.

There are plenty of do-it-yourself books and magazines out there that can help if you are trying to get the installation done on your own. If you do not have someone helping you, then it is likely that the installation of wood veneers will slip.

The veneer is attached to the cabinet with stiletto joints that often separate the veneer from the cabinets. If you have already purchased the wood veneer for the cabinets you are going to install, then you will need to prepare the surface to be used for installation.

Before you do any installation, make sure you wipe off the old veneer with a damp cloth. Sand the surface, but only slightly, in preparation for the grout to be added. Apply the grout to the surface and to the cabinet edges.

When you are ready to install the new wood veneer into place, you must begin with the bottom half of the cabinet. Slide the veneer down over the existing veneer. Be sure to check the underside of the veneer for nails or any other possible sources of damage.

Push the new veneer into place and secure using the brackets provided. To complete the job of how to install wood veneers on cabinet faces, you will need to remove the installation brackets. Lay down a clean dry towel on the surface and gently wipe away any excess dirt or dust.

The surface must be completely free of any oil or grease. Once the surface is clean and dry, you are ready to install the grout. If there is any left-over dirt or grease in the grout, it can be removed before the next step is completed.

One of the most important steps in how to install wood veneers on cabinet faces is to allow a minimum of two coats of clear veneer to dry. After two coats have dried, the final coats of urethane should be used to protect the finish.

Allow the finish time to dry thoroughly between coats, as excess heat or moisture can cause a wood veneer to crack. When finished, your cabinet should be looking as if a brand new!